Home > Windows Xp > Windows Xp Disk Error Mac

Windows Xp Disk Error Mac

After reading the Boot Camp Installation & Setup Guide (you can print this when you first start Boot Camp Assistant in OS X) I discovered that I made a big boo-boo.When Confusingly, this will allow Mac OS X to correctly recognize either a FAT32-formatted partition or an NTFS-formatted partition. Re-install windows, reboot on live-CD and recreate the swap partition. If you already partitioned, it created a 3rd partition at end of the drive. my review here

Windows 9x/2000/XPUNSUPPORTED NOTE: Windows 95/98, Windows Me, Windows 2000, and Windows XP are no longer supported by the Help Desk. GPT doesn't know anything about the active partition, and doesn't need to. Run the disk utility and make sure all volumes on your harddisk are unmounted. Apparently, you can fix this by running gptsync before installing LILO, via dropping to a command prompt and typing: chroot /target apt-get install refit /target/sbin/gptsync /dev/sda (This is from Debian Wiki

Launch the Boot Camp Assistant and select "Create or Remove a Windows Partition". Disk Error. Truthfully though, to be on the safe side also disconnect all printers and your iPod or whatever other devices you have plugged into your computer.

After rebooting, you should be back in your regular Mac OS X, with the Linux and Windows volumes gone. I have downloaded Rufus but I am not sure how to use it, which drop down options to select etc…Could anyone help? It doesn't reset the PRAM with option-command-P-R no second chime is heard, it simply goes into a Windows message how it does this with no Windows partition is beyond my comprehension. Wait until the end of the repair.

Also, you must delete the partition only through Boot Camp Assistant, not through Windows. However it gets worse. Liquid and computers don't mix. If I use bootcamp assistant (now) I don't imagine it could write the downloaded files to the USB since it's read only.

If everything has been done correctly, when you hold down the OPTION/ALT key, you will be given an option to boot to OSX and Windows. When it starts up, run diskutil list again and verify that your new partitions have been created! Hope it helps. As some people may be uncomfortable with blessing their equipment, an alternative method exists were you can chainload the LILO bootloader from the Windows XP (NTLDR) bootloader.

What do I do? click Removing the partitions can be done with "gpt": Read the "remove" and "show" sections of "man gpt". The only thing I can think of is it may be a conflict with Parallels, since it does install drivers. Note: Volumes are mounted automatically when you remove a partition.

Any idea how I can get my computer to load Mac OS X normally without having to do this annoying option key function every time? http://introbuilder.net/windows-xp/windows-xp-non-system-disk-error.php I have the parallel desktop but unluckily, I did not see all the hard drive and their partitions from parallel X. Burned a copy of the disk and used that. Reply June 18, 2013 at 12:02 am GPVajrang I installed windows7 in my macbook air(2010) it works well and good when i shut it down and switch it on again it

When Windows installer asks you were to install, pick the Bootcamp partition.5. But it doesn't work.What can I do to unlock my Mac ?!!!Help ! I need to print out my school documents out of that laptop. get redirected here Helpful (0) Reply options Link to this post by Michael Fox2, Michael Fox2 Dec 5, 2007 8:17 PM in response to Headblade Level 1 (35 points) Dec 5, 2007 8:17 PM

Windows DVD does install. Please type your message and try again. This means that the new partition sizes (60G + 17G + 15G in the example) should add up to no more than 233.4 GB.

Create the /etc/lilo.conf file as follows: # Global LILO settings boot=/dev/sda3 timeout=5 default=Linux # Kernel specific LILO settings image=/boot/ label= Linux read-only root=/dev/sda3 Next Install Lilo onto the partition

  • Helpful (0) Reply options Link to this post by Richard A.
  • One would think that one of my 3 firewire drives might show up as a boot drive. (well they're not setup as boot drives).
  • fdisk, Partion Magic) can't edit GPT.
  • Boot: Once the OSs are set up, you need to boot, and the native Mac OS X bootloader can't triple-boot.
  • If you have more than one internal hard drive, and want to use it solely for Windows then there is no reason to partition it.

The DVD drive powers up when a disk is put in but the OSX disk doesn't go into setup mode or any Apple OSX mode. Finally, there is as small hint about NTFS write support in terminal under "man mount_ntfs". However it will not recognize them properly unless the the GPT partition type is set to "Microsoft Basic Data". GRUB tries to access legacy hardware that is not present in the Intel Macs.

There is a fault where Microsoft is concerned when it comes down to install disks. I had the same problem (didn't read the manual!) Your post solved my problem. Once you have the .iso, make sure you burn it to your DVD properly. useful reference Follow these steps to resolve the issue.

Right or ctrl-click on the diskimage.img file and select "open with -> disk utility". Next, why do I have to make a new partition to install Windows? If you look at the above output of diskutil list you'll see that Apple_HFS Macintosh HD reports a size of 233.4 GB (the symbol is disk0s2). Reply October 18, 2013 at 1:54 pm dare I'm struggling for 2 week.I istanation windows via usb with Boot Camp, before I format my USB on Mac OS exstended (journaled), I

Good luck Ron.